How should the cleaning and maintenance of the sponge cutting machine equipment be carried out? The following is a detailed introduction for everyone.

Electrical equipment should be kept clean at all times to prevent oil, water and dust from entering.

When there is a circuit short circuit, it should be replaced with a fuse of the same capacity, tin silver wire can be used, and copper wire is not recommended as a substitute.

Rotating motors use rolling bearings, and the bearings should be cleaned (with kerosene or diesel) every other month and replaced with clean grease. Gears, sprockets, etc. should be cleaned and lubricated before leaving get off work every day.

When motors and electrical appliances have been parked for too long in the humid season (more than 1 month later) and used again, the insulation of the electrical appliances should be re-examined and must be dehumidified, that is, when the voltage is reduced to 1/3 of the rated value, the motor will be idling 48 Hours, in order to gradually expel the moisture, and then run at full pressure to ensure that there is no worry.

Note that the mechanical grounding must be in good condition. If the end surface of the grounding screw is oily or rusted, it should be cleaned at any time.

Pay attention to whether the exposed hoses and wires are skewed, broken, or damaged. (Sponge cutting machine)

Always check the sensitivity of each contact and interlocking device.

Use mechanical and electrical equipment in accordance with the provisions of the instruction manual.